STEPPER DRIVE MOUNTING PLATE
STEPPER MOTOR MOUNTING PLATE FOR YOUR DIY PROJECT.
This plate is made of cast iron, precision machined to accept a NEMA 34 stepper motor.
The 4 mounting holes are 5MM X .08. There are 4 counterbored mounting holes for the plate for 8 MM or 5/16 bolts. At the end of the plate opposite the motor mount is a hole for your lead screw.
The hole is 24 MM and comes with a bushing that has 24 MM OD and 19 MM ID. This bushing could be removed and replaced by a bearing.
The center distance between the motor and lead screw holes is 6.82" which was designed to use a 21 XL037 motor ulley and a 42XL037 driven pulley and a 200XL037 belt.
There are a number of other pulley/belt combinations that will work, or an idler tensioner could be attached for those that don't fit perfectly.