MILL SPINDLE WITH MORSE 4 TAPER GREAT FOR DIY PROJECT

MILL SPINDLE WITH MORSE 4 TAPER GREAT FOR DIY PROJECT

$99.95
Quantity

This is a mill spindle with Morse # 4 taper.  It was standard on early 2015 Shopmaster Mill Turn machines.

The spindle is designed to accept double sealed double row angular contact ball bearings. 

The tool end of the spindle uses a 5207 2RS1 bearing and the pulley end uses a 5206 2RS1. 

These bearings are rated for 7000 RPM. 

The pulley end of the shaft has an 8 MM X 20 MM keyway and is threaded to 25 MM X 1.5 threads for a securing nut ( not included). 

There is a 15 mm hole through the spindle for the drawbar and the spindle nose has a 40 MM flat machined for a wrench to hold it while tightening or loosening the drawbar.

A great spindle for a DIY milling machine project eliminating a lot of design and machining. Please refer to the sketch for general dimensions. 

ST-5
3 Items

16 other products in the same category: